Install the print head properly, and close the access cover. Pressing the Resume/Cancelbutton will exit the error without ink tank replacement, however, ink may run out during printing.ĥ times: The print head is not installed, or it is not properly installed (EEPROM data of the print head is faulty).
Replace the empty ink tank(s), or press the Resume/Cancel button. Open the paper output tray.Ĥ times: No ink. Remove the jammed paper, and press the Resume/Cancel button.įront door closed. Set the paper in the cassette, and press the Resume/Cancel button.ģ times: Paper jam. *1 Set the CD-R tray, and press the Resume/Cancel button. (ASF) Set the paper in the ASF, and press the Resume/Cancel button.No CD-R tray. Turn off the printer.( it must be turn off) then turn it on again.Ģ times: No paper.The number of the Reset button pressing LED Function Remarksġ time Orange Service pattern print (auto teste)Ģ times Green EEPROM print (dados da EEPROM)ģ times Orange EEPROM reset (EEPROM reset)Ĥ times Green Waste ink counter reset (Absorvente reset) When the on/off lights in green, press the Stop/Reset button the specified number of time(s) according to the function listed in the table below.(Each time the Stop/Reset button is pressed, the LED lights alternately in orange and green, starting with orange.)note: press 4 times for waste ink counter reset.* When releasing the Power button and the Stop / Reset button (regardless of order), the printer will move into a service mode. * When the Power is lit, press the Stop/Reset button two times while pressing and holding the Power button. * With the printer powered off but connected to a power source, press the Power button while pressing and holding the Stop/ Reset button.